Replace Doors And Shelves Place Shelves on shelf supports. Push down until clip snaps over shelf (see Figure 3, page 14). Replace Doors on hinges (see Figure 1, page 13). Adjust Single-Pivot Door Hinges Figure 13 All hinge types allow you to adjust door height; some also allow left-to-right adjustment. To Adjust Height: To change height, open door. Loosen Screw A (mounting screw) counterclockwise on both hinges. Move door up or down to proper position. Doors should be at the same height on all cabinets. After adjusting, turn Screw A clockwise to tighten. Do not overtighten. To Adjust Left Or Right: Check hinges to see if Screw B is available. Doors should be plumb and even with face frames. Double door cabinets should have even spacing between the doors. To adjust left or right, open door. Loosen Screw B counterclockwise, one hinge at a time. Shift door left or right as needed. After adjusting, turn Screw B clockwise to tighten. Adjust Compound Hinges To Adjust Height: Open door. For minor height adjustments, loosen Screw A on hinge body. Move door up or down to proper position. For additional adjustment, loosen Screw A on both hinge plates and reposition door. After adjustment, tighten screws. To Adjust Left or Right: Open door. Turn Screw B counterclockwise to move door away from hinge. Turn Screw B clockwise to move door in toward hinge. To Adjust Gap Between Door and Face Frame: Screw C adjusts distance between face frame and hinged side of the door, when the door is closed. Open door. Loosen Screw C. Slide hinge out or in on hinge plate to increase or decrease the gap. After adjustment, tighten screw.