Tall End Filler and 24" Deep Wall Cabinet Installation Figure 10 The Tall End Filler conceals the side of a refrigerator and supports a 24" Deep Wall Cabinet above. Tall End Fillers are shipped without a Toespace Cutout and must be inverted for left- or right-hand use before marking and cutting the Toespace. Tall End Filler Preparation Determine whether application is Left- or Right-Hand. Measure the Toekick height and depth from an adjacent Base Cabinet and transfer these dimensions to the proper end of the Tall End Filler. Follow dimensions to cut out the Toespace. Tall End Filler Attachment to Adjacent Cabinets Put Tall End Filler in place. Align top of the Tall End Filler either to the Top Wall Cabinet Level Line or to the top of an adjacent Wall Cabinet. If needed, shim the Tall End Filler so Face Frame is plumb and lined up with bottom of the Base Cabinet. Clamp Tall End Filler to the Face Frame of the adjacent Base Cabinet. Follow the "Attachment Tips for Base Cabinets" on page 8 for drilling and attaching Face Frames. See "Filler Placement for Tall Cabinets" (page 22, Figure 3) to determine if a Filler or Tall End Panel is needed between Tall End Filler and Wall Cabinet. Use angle brackets (not included) or a backer board to attach back edge of Tall End Filler to the wall and floor. 24" Deep Wall Cabinet Installation After one Tall End Filler is installed, attach the 24" Deep Wall Cabinet following the "Attachment Tips for Wall Cabinets" on page 14. NOTE: 24" Deep Wall Cabinets must be supported through the Face Frames on both sides. Support must be into wall studs, Tall End Fillers or Tall Cabinets or into soffit joists (Figure 10, Top View). Tall End Filler Attachment to Wall When the Tall End Filler is used at the end of a run, attach it to Face Frame of the 24" Deep Wall Cabinet. Also attach Filler to the wall and floor with angle brackets or backer boards.