The conversion kit includes a new set of outside guides, adaptors, and a sheet of instructions regarding the removal of the old guides and the installation of the new units. They will replace the left and right plastic adaptors. The kit includes hardware for one drawer or sliding shelf. For 24" deep cabinets only. Available in white.
Note: Merillat discontinued the drawer slide brackets. The replacement guides in the conversion kit can be used as a substitute to these older slide brackets.
Posted by Chet on Aug 16th 2016
Did the job PERFECTLY, easy to replace with old in a matter of minutes
Posted by Unknown on Aug 10th 2016
The replacement tracks for the drawers were better than original and exactly what I needed.
Posted by Rick Bowser on May 28th 2016
I would say its a mark improvement over the original design, but I think a bit unfair to make customer pay a $15.00 upgrade to repair a lifetime warranty cabinet repair when the company discontinued the original option of replacements
Posted by Unknown on Apr 28th 2016
Kit came without screws, otherwise it would have been a 5. Worked well and easily though.
Posted by Monique Rousselle Maynard on Apr 26th 2016
I had four broken drawer slides: two drawers and two drawers within base cupboards. Although it was not all too easy to remove the old adapter in the back of the cupboards, putting in the replacement slide was so quick and easy!
TIP: I was fortunate to have a little bit of space behind my base cupboards to the wall. Thus, I was able to push the little "knob" that would not displace through with a drill or screwdriver.
So grateful that I found this product and that the project is done. Once again I have organization and efficiency in my kitchen!
Posted by Unknown on Apr 24th 2016
We needed this kit to add a drawer to our cabinets, product worked great, easy to install and shipping was fast
Posted by Debbie on Feb 5th 2016
Thank you so much for providing a solution to our broken brackets! We were afraid there would be no cure!
Posted by Robert on Jan 28th 2016
Not sure how long these replacements will last. They don't appear any stronger than the poorly designed parts they replace.
Posted by William H. Young Jr. on Nov 25th 2015
Took the old one out and popped the new one in and good to go.
Posted by Karen on Nov 22nd 2015
The original bracket that held the track of the sliding shelf had broke. This replacement part of the bracket & slider fit perfectly into the hole from the previous slider bracket. It lined right up & was the exact length of the original slider. It also lined up and was level with the other slider. Only one had a broken bracket, so I only replaced one. Thank goodness they make this product.